Command Entry: -UNITS
← Prev | ↑ Chapter | Next → | Index | Symbols
Command Entry: -UNITS
Name
-UNITS
Aliases
-UN
Synopsis
Sets the units and precision for linear and angular measurements at the Command line.
Options
Scientific / Decimal / Engineering / Architectural / Fractional / Decimal degrees / Degrees/minutes/seconds / Grads / Radians / Surveyor's units
Argument Sequence
Linear unit mode (1=Scientific 2=Decimal 3=Engineering 4=Architectural 5=Fractional); number of decimal places or fractional precision (0-8); angular unit mode (1=Decimal degrees 2=Degrees/minutes/seconds 3=Grads 4=Radians 5=Surveyor's units); number of fractional places for angles (0-8); direction for angle 0; measure angles clockwise? (Yes/No).
Description
Controls the precision and display formats for coordinates, distances, and angles at the Command line. It prompts in order for the linear unit format and its precision, the angular unit format and its precision, the direction of angle 0, and whether angles are measured clockwise.
Category
system
Availability
- AutoCAD, all versions: documented.
- BricsCAD, all versions: documented.
- clautolisp: Not yet implemented: (command …) stops at it, with a "; cador:" notice on the console and no AutoLISP error; the call is recorded on the command log.
Compatibility
AutoCAD all; BricsCAD all.
clautolisp
Not yet implemented: (command …) stops at it, with a "; cador:" notice on the console and no AutoLISP error; the call is recorded on the command log. Support tier: deferred – in scope eventually, not scheduled now.